Stringing/Oozing Problem

a year ago by dohpaz42 to c/3dprinting

I am using an Ender 3 Pro v2, and I have followed multiple guides (they all say the same things) for setting up a print to prevent stringing. I’ve also switched between two filaments (Creality and Amolen) and the stringing doesn’t change at all. I have noticed that when heating up the horned, the filament just oozes out like ectoplasm even before the print starts.

I have never had this problem before, and could use some human advice.

I have upgraded/replaced the following parts in the past:

My Tweaked Settings:

load all comments

impersonator 4 points a year ago

Make sure your filament is dry.. It can make a big difference for stringing.

save

path: 0 16857172, hotness: undefined, score: 4, children: 5

dohpaz42 3 points a year ago

Since my oven can only go as low as 75°C, I ordered a filament dryer. 😠

Stupid oven.

save

path: 0 16857172 16857944, hotness: undefined, score: 3, children: 4

tonyn 3 points a year ago

Anytime I take a spool off the printer I put it back in the filament dryer. Once it's done it goes in a sealed bag with dessicant. This keeps the filament dry and prevents stringing.

Also don't use your food oven for plastic anyway.

save

path: 0 16857172 16857944 16858398, hotness: undefined, score: 3, children: 2

Wizard_Pope 2 points a year ago

I mean if you have a heated bed that works.

save

path: 0 16857172 16857944 16864964, hotness: undefined, score: 2, children: 0