All of this, and they could have just started airing the house hippo commercial again...
@lemmy.ca
I'm pretty sure the primary enzymes in saliva are amalyse and lipase. They start to break down starches and fats respective. You'd probably needs something that breaks down protiens to have any effect on your skin.
Or be mashed into a pulp so the lipase could get to work...
Having taken that test before, I would definitely get a study guide and work your way through it. Some of the questions get kind of esoteric and very specific, so even if your a Linux master, this is a thing where you should be studying for the test, rather then real life.
Checking in from right in the middle of three of those big fires in Canada. We had air quality ratings of around 600-700 (according to purple air) today.
For parts of the day it was snowing ash.
It's truly awful. But I'm thankful I don't have to deal with asthma, or dealing with being evacuated.
I saw a news article saying we had the worst air in the world today, then I checked around in purple air and were a close second. A neighboring city was showing values at 800+.
Iirc from various YouTubers who have tested these.
Biscuits being thin pressed wood fibers don't offer much if any strength to any joints.
Dowels and dominos can help strengthen long grain to short grain joints.
Either will help with alignment with long grain to long grain glue ups.
I can't provide sources, so take this with as many grains of salt as you wish.
Personally I find there to be less new daily content on lemmy, so it ends up self limiting as I see the same posts again. Might just be what I’m subbed to, and or how I sort. But I do end up spending less time here than I did reddit, or I currently do on youtube.
Cups, tablespoons, teaspoons, in cooking.
Feet and inches should still be common in construction. At least it's how wood is sold.
We still use letter / legal paper printer measured in inches.
My bathroom scale is in pounds.
I'm sure there are some others, but we're not fully metric on everything.
I saw people chatting it up about how much better it eas. I finally installed and did the registration and signed in. Loaded my model, dealt with the wonky mouse controls, supppored, sliced, saved. Attempted to print, and it failed on the first layer. My first failure on that printer.
Went back to chutitubox and back to working prints.
I use tasker to pull the astronomy picture of the day.
thanks for using Leebra!
go to feed...