I'm happy about that now. When I was frantically scrubbing spills from the dye bath I used for the keycaps, less so.

Not yet. Truth be told, I'm still working on the firmware :-)

Yes, the base is a single 3d printed part, plus an acrylic bottom plate. The scaffold legs slot into the case and are screwed in at the bottom.

Thanks! That, if I’m being honest, was the primary design concern.

I don’t have a giant resin printer, but Elecrow does. They also did the laser cutting and the PCBs. Not the quickest turnaround in the world but they do good work and their prices are remarkably low.

What’s your approach to stripping the enamel from the wire?

The only case I’ve ever seen where they make sense!